Finish of Dynatex might be always along the shape of sbstrate. Before the application of Dynatex, please repair the defect such as uneven, crack, different level, etc. of surface carefully. Otherwise, it can not have a good finish and may loose a lot of Dynatex materials. It is required to have a completely flat surface.

	There are 2 choices to have a Dynatex finish on Expansion Joint. Covering the expansion joint ? Filling up the Expansion Joint with resin mortar* with fiber mesh. and apply Dynatex on all substrate. After the completion of dry, it shall be cut along with the place where there was joint lines.
	Another way is to leave the joint line when the Dynatex is applied. Before the application, mask the joint lines completely